(When both monitors are clones, the cursor tracking is accurate when one monitor is an extended desktop of the other, the cursor is offset). It was rather frustrating because TB kept asking us questions we had already answered (eg, “Are you using Windows 10?” when we had already provided all the specs of our software and hardware).Īnd so it went for about a half-hour…TB rounded up the usual suspects (eg, do the resolutions match?, is the scaling at 100%%, is the scaling disabled?) and nothing changed.Īnd of course nothing is going to change because TB did nothing we hadn’t already tried ourselves, and had already explained to TB.Īnyway, bottom line, until either TB or Ugee work things out, separately or together, the two products (Harmony Advanced and Ugee UG-2150) will not play nice together in a dual-monitor setup in extended mode. Toon Boom tech support sent us “Team Viewer” which we installed and which allowed Toon Boom to control our PC. Just got offline from a remote access session. We are using a Ugee UG-2150 tablet (that Toon Boom does not support). In the Camera or Drawing view, start drawing to test your brush settings.Our problem is cursor offset when using a dual monitor setup in extended desktop mode.Either close or set aside the Brush Properties dialog.A higher setting will round sharp corners and reduce the amount of control points for the resulting vector shape. Use the Contour Smoothing slider to set the amount of smoothing Harmony should perform on your stroke's contour.A higher setting will prevent your line from being shaky, but is liable to reduce your drawing precision and to round sharp corners into curves. Use the Centerline Smoothing slider to set the amount of smoothing Harmony should perform on your stroke's direction, curves and corners.If you want your brush tip to be at an angle, use the Angle slider to rotate your brush tip.If you want your brush tip to have uneven dimensions, use the Roundness slider to shrink the brush tip vertically all the while preserving its horizontal size.If you want your brush to keep the same size relative to the camera frame when the camera zooms in on or zooms out of the scene, check the Proportional to Camera option.If you don't want the pressure on your pen to affect the brush size, set this parameter to 100%. The minimum size is set to a percentage of your brush tip's maximum size, which is 25% by default. If you are using a pressure-sensitive pen tablet, use the Minimum Size slider to set the size of your brush when using your pen with very little pressure.When drawing with a pressure-sensitive pen tablet, your brush's size will range between its minimum and maximum size, depending on the amount of pressure you put on the pen when drawing. NOTE When drawing with a mouse, your brush is always at its maximum size.

Toon boom harmony brush